PLA Plus Filament 1.75mm Black 10KG for FDM 3D Printers

Looking for a spool that holds up under load? This ELEGOO PLA Plus in black starts from American Natureworks 4032D raw material, chosen for low warpage and low shrinkage, and it prints without much odor in the room.

Toughness is where it pulls ahead. Compared with standard PLA, the modified formula gives better tensile strength and higher impact strength, so parts flex instead of snapping and deform less. Cooling also behaves well, which helps overhangs and gives suspended models a better shot at finishing cleanly.

Surface finish and layer bonding matter just as much. Deposition is accurate and layers grab onto each other firmly, so the finished print looks smooth and doesn't peel apart. Printing temperatures stay on the low side, and the thermoforming dimensions hold steady, which keeps the whole process simple.

• Neatly wound reels: full mechanical winding, a secondary sub-winding pass and strict manual inspection keep the strand tidy, cutting down crossed turns and tangles that lead to snaps or breaks.
• Tight tolerances: these 1.75mm PLA+ filaments hold a dimensional accuracy of +/- 0.02mm, so feeding stays smooth and flow through the extruder stays consistent.
• Dry and sealed: every spool is fully dried before packing and vacuum sealed with desiccants, which guards against moisture and dust, clogs and bubbles.

1.75mm FDM 3D printers on the market are widely compatible with it. Load the black reel for brackets, jigs or display pieces where you want a clean gloss and dependable strength.